This time I did it different. My previous printers had daily buildlogs and status-updates, but this one was build on the QT.
Therefore, you get an exclusive and packed info right now. Make yourself comfortable and enjoy, the secret is about to be lifted:
The tiny DICE is now ready for rebuild. A few small but meaningful changes were made so that the DICE is fun for everyone. So was waived the mains voltage of 230V in the printer and changed to protective low-level-voltage of 24V. In addition, the print-bed is simpler and the connection is improved. With the relocation of the power supply to the outside, there is now room for a Raspberry Pi in the printer!
As a little "inbetween"-update, I give you an updated front-enclosure with integrated DICE-logo.
Who knows my video from 2015, where I show off a magnetic hotend changer for the sparkcube, you are going to have a Déjà-vu now. I made a very similar system to change the printhead for the tiny printer DICE.
When equipping the DICE with the new Magnetic interchangeable printheads for the DICE, there comes the "problem" how to get two different extruder-motors to run with this setup easily. Because, depending on which extruder is going to get used to print, the corresponding stepper motor has to be controlled with the matching stepper driver.
|
follow me: |
information: |
  |